Kitchen Sink Handle Came Off

You ll need to find the set screw most times it s directly under the handle and use a 3 32 allen wrench to remove it by turning counter clockwise until it comes out save for later.

Kitchen sink handle came off.

I did put some wd 40 down the hole where you would insert the allen wrench to tighten. Single lever faucets use a lever style handle to turn the water on and to adjust the water temperature. Here s what you ll find on a kitchen sink assembly. This type of faucet takes up less room on your counter top and.

You can insert a small allen wrench at least a half inch on the faucet side not sure if something sheared off in there or not. You can t grab the flattened edges with the handle in place. Nothing fell out when the handle came off. On many models such as kohler single handle faucets you can unscrew and remove the faucet handle then wiggle the spout back and forth while you apply upward pressure and the spout should pop off.

Even if the handle still functions properly a cracked or damaged handle ruins the appearance of your kitchen faucet. However kitchen sinks often have a few extra parts. For any handle performance issue we ll start by removing the handle itself. This is the piece that attaches to your kitchen faucet or faucet.

Hot water line shut off under sink should be a screw in the center of the handle. The diverter which is smaller than a dime is inserted in the valve housing. This operation is usually fairly simple and you may not need to shut off the water. Single lever faucet issues.

A single handle ball type faucet. Hot water faucet handle should be an allen screw on the handle. Handle fell off maybe screw fell off. Kitchen sinks include many of the same parts that you ll find on any sink like a basin faucet control lever or handles and hot and cold water supply lines.

If the allen screw is stuck or if you strip it so it won t come out remove the cap with the handle still in place. Instead for this kitchen faucet repair cushion the jaws of pliers and grip the round edge below. Occasionally the set screw hole is covered by a plug which you can pop off with a small flat head screwdriver.